Instructions

▶ Wipe the stoma and its surrounding skin with warm water and dry, remove the sclerotic keratinised skin and stain, keep the skin around the stoma clean and dry.

▶ Measure the size of the stoma with the measuring card supplied. Do not touch the stoma with your fingers while measuring it.

▶ According to the measured size and shape of the stoma, cut a hole of an appropriate size on the film of the ostomy flange.The hole diameter is usually 2mm bigger than the stoma diameter.

▶ Peel the protective release paper on the inside ring of the flange and stick aiming at the stoma(It is good to blow air into the bag before sticking, in order to prevent thin films from sticking to each other), and then strip the protective release paper on the outside ring, and carefully paste up from the middle towards the outside.

▶ In order to make stickup secure(especially in areas and seasons with low temperature), you should press the pasted part with your hands for several minutes, in turn, the hydrocolloid flange could increase viscosity with the rising temperature.e clamp can be used many times).